Quality Swimming Pool Heat Pump & Chiller Manufacturer

When installing a heat pump, we recommend installing it outdoors in a well-ventilated area. The air source heat pump must have a base before installation, because frost will form when used in winter, and water will flow out during the defrost process, which needs to be drained away. And the base is made to facilitate the drainage of water generated during the defrost process. If it must be installed indoors, it must be well ventilated, or there must be a large space and a heater for heat exchange.

The issue to pay special attention to is: the water flow rate must be fully matched, otherwise the water flow protection will occur and the heat pump cannot be started. Try to make the return pipe as large as possible. For example, if the heat pump is 1.5" in diameter, it is recommended that the water inlet pipe be 2" or above.

Our heat pumps have a 1 year warranty. If you encounter problems during use, you can send us photos and videos as a basis for judgment, and we will provide a solution.

When choosing a chiller, you need to consider the cooling capacity required based on the size and needs of your pool, and then select the chiller model that suits your pool. If you don't know how to choose the right refrigerator model, you can tell us the following information:

a. What are the specific dimensions of your pool (such as length, width, depth)?

b. How long (time) do you want to cool the pool from the initial temperature to how low the temperature (target temperature)?

After we know the above information, we will calculate the required cooling capacity and recommend the appropriate model for you.

The daily maintenance of AQUA heat pump focuses on "preventive maintenance" and "intelligent management". By regularly cleaning the heat exchanger, checking the water circuit and electrical system, and setting the antifreeze mode appropriately, equipment efficiency can be significantly improved, energy consumption reduced, and service life extended. If it is not used for a long time, be sure to perform the three-step operation of "drainage + power off + protection" to ensure a safe winter.

A. Daily operation points:

a. Check that the power supply and waterway are smooth before starting the machine.

b. Set the temperature and humidity through the touch screen, and the device will run automatically.

c. Supports remote monitoring and real-time status control.

B. Maintenance suggestions:

a. Clean the air side heat exchanger and filter regularly to maintain good ventilation.

b. Check that there are no leaks in the pipes and pay attention to anti-freezing in winter.

c. If it is not used for a long time, it is necessary to cut off the power and drain water to avoid freezing damage.